Epoxy Floor Repair in Thornton, CO

Common failures here

Coated floors fail for predictable reasons in this climate. DIY kits applied over unground concrete peel under hot tires in summer and under salt and ice in winter. Basement coatings blister when moisture pushes up from the soil. Thin coatings wear through where studded or chained tires turn. Sometimes the coating is fine but the concrete under it has spalled from years of salt exposure before it was coated.

Diagnosing the problem

Before quoting repairs, we test adhesion, check thickness, measure moisture and look at patterns. Peeling only in tire paths suggests poor prep or hot tire pickup. Blisters in a basement suggest moisture vapor. Flaking near the door with pitted concrete underneath points to salt damage. The right repair depends on the cause.

Repair options

Spot repair

For limited damage on an otherwise sound floor, we grind out the bad area, patch the concrete and recoat. Flake blends can be matched.

Recoat

If the coating is bonded but worn or dull, we sand and apply a fresh topcoat.

Full removal and replacement

When adhesion is poor across the floor, we grind off everything and install a new system with proper prep.

Spalling repair

Salt damage leaves pits and flaked areas, often concentrated near the garage door and where cars drip. We grind out loose material, fill with polymer-modified or epoxy mortar and grind flush. Once the slab is sound, a coating keeps further brine out.

Crack repair

Expansive soils cause cracks to open and shift. We route cracks, fill them with rigid or flexible material depending on movement and bridge them in the coating system. If a crack is actively heaving, we will tell you so before coating.

Basement blistering

Blisters in basement coatings almost always indicate moisture vapor. Repair involves removing the coating, testing moisture and installing a vapor-mitigation primer before recoating.

Doing it right

Every repair follows our full standards: mechanical grinding, moisture testing, proper thickness and topcoats rated for salt and UV. We explain what went wrong so it does not happen again.

Questions

Can you coat over my peeling floor?

No. Loose material must come off.

Will repairs be visible?

Flake floors blend well. Solid colors may look best with a full recoat.

How long do repairs take?

Spot repairs and recoats take one day. Full replacement takes one to three.

Get an evaluation

Contact us with photos or book an inspection.

Repairing floors before selling

A peeling garage floor can make buyers wonder what else was done cheaply in the house. Before listing, many homeowners ask us either to repair the coating or remove it and leave clean, ground concrete, or to install a new floor that becomes a selling point in listing photos. We can usually complete these jobs within a week of the first call.

Shop and commercial repairs

In shops and warehouses, worn coatings expose concrete that dusts and absorbs fluids, and lifted edges become trip hazards. We repair traffic lanes, rebuild damaged joints and recoat sections after hours so operations continue. Restriping often happens at the same time, so the space looks organized again when your crew returns the next morning.

Not sure what caused your failure? Send a few photos showing the worst areas and a wide shot of the whole floor. We can often tell you the likely cause and the probable repair path before we ever visit.

Repairs are backed by the same written warranty as our new floors, because they follow the same preparation and material standards from start to finish. We stand behind every repaired area just as we do with brand-new installations.